Talar Dome Fracture – Blog by Louise Holland
Is your ankle pain persisting after a badly sprained ankle injury?
The Talus is one part of the bones in your ankle. It is the highest bone of the foot, located just below the point where the lower leg unites with the foot.
The Talar Dome refers to the upper rounded part of the talus that joins upward with the bones of the lower leg tibia and fibula to form the ankle joint. The talus not only plays a vital role in the movement of the ankle joint required during walking, running, jumping and in all the activities that we perform on our feet, but also supports the body weight as we stand or walk.
Like the joint surfaces of all the bones forming a moveable joint, the upper surface of the talar dome is also covered with cartilage that reduces the friction between the two bone surfaces during movement at the joint. For this reason, fractures of talar dome can also be called:
• Osteo (bone) chondral (cartilage) fractures: that is fractures involving both bone and cartilage, or,
• Trans (through) chondral (cartilage) fractures: As the injurious force causing the fracture is transmitted through the cartilage to the underlying bone.
Talus fractures are not a common occurrence; however, their incidence is greater in active young adults such as athletes or in postmenopausal women. Men are twice as likely to acquire an ankle fracture.
A talar dome fracture can be caused by:
• An inversion ankle injury (the foot rolls inwards accidentally), about 2%-6% of acute ankle sprains are associated with a talar dome fracture.
• A direct injury to the ankle (such as an object hitting where the talus joins the leg bones)
• A combined inversion injury with a compression element of the joint into the ground.
A fracture usually involves the shoulder of the talar dome on either the inner side or the outer side. Both sides are only rarely involved simultaneously. Fractures of the inner talar dome may occur even in the absence of trauma for reasons which are still unclear.
Mechanism of injury:
(Stages of fracture)
A transchondral fracture occurs when a damaging blow hits the cartilage surface of the talar dome and is transmitted to the underlying bone, causing fracture of the bone and/or cartilage. There are four different categories of fractures to the Talar dome:
Stage I: This involves the force hitting the cartilage-covered surface of the talar dome. The cartilage remains intact, while the underlying bone collapses under the force, leading to an irregular joint surface. This irregular surface causes pain during joint movement.
Stage II: This involves cracking (chipping) of cartilage as well as bone
Stage III: The fractured fragment detaches completely from the bone, but still remains in its place
Stage IV: The fractured fragment becomes loose and gets displaced into the joint space.
As a result of the damaged joint surface and/or the fractured fragments present in the joint space, there is pain and inflammation and the movement at the joint becomes painful and restricted.
Moreover, injury to the bone may damage its blood supply, leading to aseptic necrosis of the bone (death of bone cells in the absence of an infection). The overlying cartilage derives its nutrition from the fluid in the joint space and therefore does not suffer from a lack of blood flow.
Aseptic necrosis is a major factor delaying the healing of talar dome fractures.
A great number of talar dome fractures usually occur with an ankle sprain, a result of an accidental inward twist of the foot.
Along with the pain of damaged ligaments, there is a deep-set pain in the ankle, which persists for longer, even after the initial intense pain has subsided.
Return to activity leads to recurrent pain and swelling. Especially in any weight bearing activities.
There may be stiffness of the joint (a locking sensation during movement) and crepitance (a grating or crackling sound on movement).
There may be weakness and instability of the joint.
Talar dome fractures are often missed at the initial examination following an ankle sprain or injury.
The treatment given for the sprain or injury usually fails to treat the unidentified fracture. The result is a persistent deep pain in the ankle and recurrent swelling with activity.
Follow-up X-rays, about 4 to 6 weeks after injury, should be taken to rule out any fractures of the talar dome.
Moreover, in the case of fracture of the outer side of the talar dome there is tenderness in front of the outer bump of the ankle with the foot bent downwards.
However, if there is tenderness behind the inner bump of the ankle with the foot bent upwards, the inner side of the talar dome is involved.
If initial X-rays do not show any evidence of fracture despite the signs and symptoms, a bone scan, CT scan or MRI may be advised. These diagnostic tools are especially helpful in diagnosing Stage I osteochondral defects and in assessing the extent of the damage to the bone.
The treatment of a talar dome fracture is often delayed due to late diagnosis. However, it is recommended to initiate the treatment with a conservative approach immediately if you suspect, which includes:
• Immobilizing the joint using an ankle brace or walking cast (moonboot) for about six to ten weeks
• Using crutches to keep the load off the fractured bone
• Pain killers
Non-displaced fractures of the talar dome usually heal with this treatment approach. However, even if conservative treatment fails to resolve the problem, it does not complicate the problem any further nor does it cause any problem if an operation is planned afterwards.
Surgery is required for:
• Healed fractures leaving a defect on the cartilage covering the joint surface of the bone; this causes pain and instability of the joint
• Displaced fractures (fractured fragments dislocated into the joint space)
Once the immobilizing cast is removed, the condition of the bone should be re-evaluated. If there are any symptoms of joint dysfunction such as:
• A locking of the ankle joint
• Instability of the joint
• Pain in the joint (that goes away with injecting a local anesthetic)
An MRI or other diagnostic tools should be employed to check for the displaced fractured fragments and for any residual defects in the cartilage covering the joint surface of the bone.
Surgical treatment involves:
Arthroscopy (repairing the damaged bone with the help of an arthroscope):
This involves making a small incision through which an arthroscope (a small tube with an optical system to look into the joint, attached to a monitor or TV screen) is inserted to clean the surface of damaged cartilage by grinding away the defect. In some cases, this arthroscopic procedure is accompanied by drilling the bone under the cartilage to stimulate blood flow to the area and speed up healing and to prevent aseptic necrosis of the bone.
Stage I and II fractures usually require arthroscopy with or without drilling of the underlying bone
Internal fixation using pins and screws
Open Reduction and Internal Fixation:
This involves opening the skin for reduction (fixation or correction of a fracture) with the help of internal fixation (joining fractured fragments of bone using pins and screws placed inside the bone).
This requires a relatively larger skin incision than is used in arthroscopy and may involve the placement of a graft to rectify the shape of the damaged talar dome.
Stage III and IV fractures do respond to the arthroscopic approach, but often require open surgery and graft placement.
After complete healing of the fracture, proper rehabilitation is required to improve the strength and stability of the joint as well as its range of motion.
In our clinics, we can provide special tests and assess to differ if you have a lateral ankle sprain or a talar dome fracture. We can help in the rehabilitation process pre and post surgery if required.